Handling The Nfc - Casio ET-L10 Series User Manual

Removing the nanoSIM/microSD card
1. Turn the terminal off (shut it down). (The terminal must be shut down.)
2. Remove the nanoSIM/microSD card tray. (Steps 2 and 3 in the installation procedure
on page 20)
3. Remove the nanoSIM card or microSD card from the nanoSIM/microSD card tray.
4. Install the nanoSIM/microSD card tray in the terminal and close the cover.
(Step 5 in the installation procedure on page 20)
Precautions for Use
• The front and back of the card are different, so the card must be oriented correctly
when inserted into the slot. Take care when inserting the card as attempting to insert
the card incorrectly could damage the card.
• Touching the contact area when installing a card could result in damage to the card
due to soiling or an electrostatic charge.
• When turning off the terminal, be sure to select "Shutdown" and not "Sleep".
• nanoSIM cards and microSD cards can be installed either separately or both at the
same time.
• Always install the nanoSIM/microSD card tray, even when no nanoSIM/microSD
card is used.

Handling the NFC

The NFC is a technology of contactless IC card for short range communication that enables
writing data to card and reading data from the card by applying the card close to the NFC
Reader.
The integrated NFC can read a contactless IC card used typically for employment
identifi cation, etc.
1. Hold the card fl at against the NFC reader on the back of the terminal.
Precautions for Use
• Do not apply card while it is overridden by other card. The NFC may not read it
correctly.
• A metal object near by the NFC Reader may cause the NFC not to read card
correctly. Take the card out of a wallet if the wallet is with metal object before
applying it to the NFC Reader.
• Apply card in parallel with the NFC Reader to touch the NFC Reader with the card.
• The NFC reader function in the terminal uses very weak radio waves that do not
require a radio station license.
• Frequency band used by the NFC is 13.56 MHz. Secure a suffi cient space between
the terminal and other reader/writer located in the vicinity. Make sure also that a
radio station employs the same frequency band does not locate near by prior to using
the terminal.
⇨
21