Advertisement
Parts List: 960 Motorized Adjustable Bench
Item Description
1
Work surface (STD. or ESD)
2
960 Leg Sub-Assy-RT & LT ea
3
Front Support Beam 1.5"H
4
Std. Support Beam 3"H
5
950/960 Modesty Panel
A
Hex Head Bolt 1/4-20x.75
B
Flat Washer 1/4"
C
Hex Head Bolt 5/16-18x.75
D
Flat Washer 5/16
Hardware Kit: HWR 465
1/4-20x.75
1/4-20
HH Bolt
Flat Washer
CAUTION: Do not operate Motorized /cylinders without the weight of the worksurface on the
frame. To do so may cause a vacuum in the lines and possible damage.
Be cautious to hold the leg assemblies together when turning workbench over after
assembly making sure they do not separate.
1.
Place Bench Top (Item 1) on clean surface with underside facing up.
2.
Loosely attach front and rear support beams (items 3 & 4) to leg assemblies (item 2) using
5/16-18 x .75 hex head bolts (item D) and 5/16 flat washers (item E).
3.
Loosely attach modesty panel (item 5) to leg assemblies (item 2) using 1/4-20 x .75 hex head
bolts (item B) and1/4 flat washers (item C).
Secure motorized pump system to the worksurface of 60" and longer benches using six (6)
4.
1/4-20 x .75 hex head bolts (item A) and six (6) 1/4 flat washers (item B) as shown in Figure 2.
For 48" benches secure motorized pump to the modesty panel using six (6) 1/4-20 x .75 hex
head bolts (item A) and six (6) 1/4 flat washers (item B) as shown in Figure 1. Align mounting
slots in bench frame assembly with inserts in worksurface and attach using 1/4-20 x .75 hex
head bolts (item A) and1/4 flat washers (item B). Square the frame and tighten the front and
rear beams first. Then tighten the worksurface bolts being careful not to over tighten.
Qty. Item Description
1
E
1
F
1
G
1
H
1
I
20
J
20
K
8
8
5/16-18x.75
5/16-18
HH Bolt
Flat Washer
Screw, 10-32x1.00" PPH
Screw, #6x .50 PPH/SMS
Tie Mount, Plastic
Cable Tie
Nut, Well Nut 10-32 Neoprene
Brkt, Motorized Hgt. Adj. Switch MTG
10-32x 1.00L
PPH Screw
6
(Ref. Figure 1&2)
Qty.
2
4
4
4
2
1
Well Nut 10-32
Advertisement
