Advertisement
Parts List: QS-930 Hand Crank Adjustable Bench
(Ref. Figure 1) Hardware Kit – QS-HWR461*
Item Description
1
QS Worksurface
2
930 Leg Sub-Assy-Rt & Lt
3
Front Support Beam 1.5H
4
930 Modesty Panel
5
930/940 Stiffener Beam
A
Hex Head Bolt 1/4-20x.75
B
Washer, 1/4 Flat
C
Nut, 1/4-20 Hex Keps
D
Bolt, 1/4-20 x .75 SQ. Head GR2
1/4-20x .75
1/4-20
HH Bolt
Flat washer
CAUTION: Do not operate hand crank cylinders without the weight of the worksurface
on the frame. To do so may cause a vacuum in the lines and possible damage to the
system. Be cautious to hold the leg assemblies together when turning workbench
over after assembly making sure they do not separate.
Reference Assembly Drawing Above
1.
Place worksurface (item 1) on clean surface underside facing up.
2.
Loosely install the front beam (items 3) and leg assemblies (item #2) to the worksurface
using 1/4-20x.75 hex head bolts (item A) and 1/4 flat washers (item B).
Note: Before installing leg assemblies (item #2) to the worksurface attach pedestal end
caps (item H) and floor glides (item J) at this time.
3.
Loosely attach the front beam (items 3) to the leg assemblies (item #2) using 1/4-20x.75
hex head bolts (item A), 1/4 flat washers (item B) and 1/4 hex keps nuts (item C).
4.
Install part of the modesty panel (item 5) hardware
1/4-20 x .75 SQ. Head GR2 Bolt (item D)
to each leg assemblies (item 2) by sliding the head of
the three bolts (item D) on each pedestal upper channel
as shown.
Qty. Item Description
1ea
1
1
1
26 *
34*
8*
6 *
1/4-20x .75
1/4-20
SQ.H Bolt
Hex Keps Nut
(This will require no less than two persons)
1
E
Screw, 10-32x 3.00L PHP
F
Washer, # 10 Flat Zinc
G
Nut, #10-32 Hex Keps
H
Cap, 2.00" x 3.00" 10-14 Ga
J
Floor Glide 5/16-18 x 1.75 x 1.625Dia
K
Bracket, 950/950-QS Hand Crank 1.50H 1*
L
Screw, #6 x .500 PPH SMS Zinc
M
Cable Tie, Mount Plastic (#6)
N
Cable Tie, #8
10-32x 3.00L
PHP Screw
4
Qty.
3 *
3 *
4*
4*
4*
4*
4*
# 10
#10-32
Flat washer
Hex Keps Nut
3 *
Advertisement
