About The Matrox Nrg Rackmount; Connection Overview - Matrox NRG User Manual

About the Matrox NRG rackmount

Matrox NRG comes pre-installed on a standard 1RU rackmount shelf. If you have a single
unit NRG model, there is space on the shelf for another Matrox appliance next to it.
For more information on how to install other devices on the shelf, go to our website at:
https://www.matrox.com/en/video/products/rackmount-kit-instructions.

Connection overview

This section describes how to connect your devices and power on Matrox NRG.
1 Before you connect any devices to your Matrox NRG, make sure that the power switch
on the front panel is in the OFF position. This ensures that no power is coming from the
DIN 4-Pin 12V d.c. outputs.
Connect your Matrox devices to the DIN 4-Pin 12V d.c. outputs on your Matrox NRG.
2
Make sure that you insert the connectors in the correct orientation (i.e. locking latch is
in the correct position). Do not use excessive force to insert the connectors.
Output 1 supports 12V d.c. 3A devices only. Devices requiring more than 3A may not
boot or function as intended if they are on output 1. Verify the voltage and/or current
requirements specified on the Matrox device(s) you intend to use with Matrox NRG.
Matrox NRG-5-1DB (single unit model)
Power to the 12V d.c.
outputs is OFF
12V d.c. 3A
devices only
12V d.c. 5A devices
Matrox NRG User Guide 9