Hardware Required (Sold Separately); Optional Hardware (Sold Separately); More Information - Matrox NRG User Manual

 Mounting screws.

Hardware required (sold separately)

Depending on your device and setup, you may need the following hardware:
 IEC power cables.
 CAT5e, CAT6, or CAT7 cable.
 GPIO Female DB-9 low profile connector.

Optional hardware (sold separately)

You may also need any of the following hardware (available for purchase from Matrox):
Spare and/or replacement power supply module(s).

 Spare and/or replacement power output cables.

More information

Your Matrox NRG User Guide provides information on installing and connecting your Matrox
hardware, updating your firmware package, and using the NRG configuration software.
Be sure to check for any last-minute release notes included with your product. Also, check the Matrox
website (www.matrox.com/video) for the latest Matrox software, technical support, and product
information.
* All NRG-compatible Matrox appliances include IEC power cables that can also be used with Matrox NRG. For North America
only, use a cord set (provided by Matrox) bearing P/N FCABLE050 with the NRG. If needed, you can purchase additional cables
from Matrox.
† You can purchase additional power supply modules from Matrox (part number NRG-5-PM)
‡ You can purchase a set of four 6-foot cables (double-ended DIN 4-pin male with lock) from Matrox under part number CAB-
DIN4-6FT-4.
*
†
‡
Matrox NRG User Guide 7