Other Troubleshooting - Maxwell AutoAnchor 710-6 Owner's Manual

OTHER TROUBLESHOOTING

not turning or counts erratically displaying a
large number. The screen may display Sensor
unstable and the unit may beep when turned off
or locked.
windlass
This applies to rope/chain rode only.
deployed and counts out when rode is retrieved.
pressed.
point.
AFTER ANY SENSOR REPAIRS OR CHANGES:
DOCK THE ANCHOR AND RESET THE SENSOR. SEE PAGE 37.
FOR ADDITIONAL TROUBLESHOOTING:
Contact AutoAnchor support
POSSIBLE CAUSE/ACTION
through the windlass or there may be some
external interference.
may be faulty.
plug is not used the wires must be soldered. All
wires must be connected (including the drain)
and shielded cable must be used.
Total length of rode has been set to off.
AutoAnchor then operates as a counter only.
If the sensor indicator (arrow) is still pulsing, this
is not a fault. The rode is changing from rope
to chain.
The unit is not receiving correct direction
swapped.
Change the wiring and check the direction of
windlass rotation. If the brown and white wires
are connected, also check that they are correct
after you have changed the wiring.
revolution. The chainwheel will run on slightly
with momentum.
Using the Automatic function the rode release
49