Voltage Levels - Maxwell AutoAnchor 710-6 Owner's Manual

2.5 POWER SUPPLY
THE POWER SUPPLY MUST BE DISCONNECTED WHEN INSTALLING,
CONNECTING OR CHANGING THE WIRING
Check battery polarity before connecting power and ensure output terminals will not short.
Refer to the manufacturer's speci cations
switch should be installed for controls if the main breaker or isolator is not readily acessible
from the helm.
become the common negative return (ground).
2.5.1 WINDLASS INSTALLATIONS
with all other windlass controls eg. toggle switch, remote switches, deck switches, other
AutoAnchor devices. Power supply must not be from the motor positive near the
windlass.
2.5.2 MULTIPLE BASE STATION INSTALLATIONS
The master base station must be powered up when using a slave base station application.
are connected to the same base station they must be powered by the same supply,
or relays must be used as a means of isolation. To maintain power to the windlass it is
recommended that the windlass be attached to the master base station.

2.6 VOLTAGE LEVELS

Minimum Voltage Required
If the windlass is already operating, this is the
12V DC System
.
15
if 2 products
24V DC System