Part 6 Troubleshooting; Troubleshooting Messages - Maxwell AutoAnchor 710-6 Owner's Manual

PART 6 TROUBLESHOOTING

troubleshooting. These messages are designed to assist the user. They may be
information messages, for example that the console is locked, or the sensor is tuning.
They may also be diagnostic messages, for example, that the sensor installation is not
compatible or the power supply is wired incorrectly.
information on the following pages.
Please Note: Th
caused by a fault with the AutoAnchor.
TROUBLESHOOTING
MESSAGES
Note: Unless the fault is
in the solenoid wiring the
AA710 will operate the
windlass in manual mode
when this message is
displayed.
operate windlass.
The voltage displays on the
status bar.
controlled.
incorrrectly.
POSSIBLE CAUSE/ACTION
connections.
wrong size there may be voltage drop between the battery and the
Appears when switching on the AutoAnchor.
or down terminal.
The wiring diagram has not been followed. Power is backfeeding
to the AutoAnchor from a supply outside the control circuit. Refer to
deck switches powered from separate sources.
46
They are not