Sensor Setup - Maxwell AutoAnchor 710-6 Owner's Manual

3.9.4 TO ENTER THE INSIDE AND OUTSIDE DIAMETER
Enter the measurement in mm or metric
inches (depending on the units selected).
again to return to start screen.
3.10 SENSOR SET UP
Standard - Applies to all AA sensors, reed switch
baseplate sensors and proximity sensors. The default setting should
Note:
3.10.1 MOTOR DRIVEN SENSORS
To select the motor driven sensor:
Increase or decrease the Gearbox ratio.
to return to start screen.
3.11 SWAP CONTROLS
Note: This feature can not be used to correct wiring errors.
Inside diameter -
rode fully deployed
= Up and = Down.
Rode
start screen.
34
rode fully retrieved