Set Up And Testing - Maxwell AutoAnchor 710-6 Owner's Manual

4.3.1 WHEN CONTROLLING A WINDLASS
4.3.2 WHEN CONTROLLING A THRUSTER
damage resulting from failure to follow the installation and operating instructions or the use
of the AutoAnchor in a way that may cause accidents or damage or that may violate the law.

4.4 SET UP AND TESTING

if the windlass selection is wrong or the windlass is not standard (eg it is installed with a
different chainwheel or motor).
4.5 WINDLASS OPERATION WITH THE AA710
4.5.1 PLUG & PLAY SENSOR TUNING
loaded, the sensor is reset or there has been
a loss of sensor signal.
Installation and set up must be complete and the anchor must be
docked before starting this process.
Clear the AutoAnchor to zero if necessa
display "Sensor tuning". Continue deployment until this message
changes to "Tuning done". This must be done in one continuous
operation without taking your nger off the button until the
"Tuning done" message displays. This could take up to 10 turns
of the windlass. Retrieve the anchor to the docked position and clear
to zero if needed.
Note: If you do need to take your nger off the button, start the
process again.
Rope/Chain System: The default rode set up is chain only. If rope
and chain rode is selected without the correct sensor and magnet set
message will display. Check the installation and rode set up and reset
the sensor to restart the tuning process.
37