Deregistering A Base Station - Maxwell AutoAnchor 710-6 Owner's Manual

3.2.7 ADD EXTRA BASE STATIONS (SLAVES)
which base station is to remain the master and then follow the directions below to register
the slave stations. To maintain power to the windlass it is recommended that it be attached
to the master base station.
Slave: Hold down the registration button, on the slave station, for 6 seconds until the
is in registration mode.
Master:
base station.
Note:
station when it is next turned on.

3.2.8 DEREGISTERING A BASE STATION

I
f a base station is removed or replaced it must be deregistered from the system. To do
and restart the system.
If you have deregisterered a slave
If you have deregistered a master base station the system must be set up again as if it is a
new system.
801D
20
803D
815A