Unpacking And Testing Fireplace; Installation Overview - Paramount Fitness BLT-999W-13/42 User Manual

WARNING: Due to high temperatures, this electric fireplace should be located out of traffic. Keep combustible
materials such as furniture, pillows, bedding, papers, clothes and curtains at least 36" from the top of the heater.
WARNING: Never locate this electric fireplace where it may fall into a bathtub or other water container.
CAUTION: Do not expose the electric fireplace to the elements (such as rain, etc)
WARNING: To prevent contact with sagging or loose insulation, the electric fireplace must not be installed
against a vapor barrier or exposed insulation. Localized overheating could occur and a fire could result.
UNPACKING AND TESTING FIREPLACE
Carefully remove the unit from the box. Prior to installing the unit, test to make sure the unit operates
properly. To do this, plug the unit's power supply cord into a conveniently located 120 Volt grounded outlet.
INSTALLATION
WARNING: RISK OF FIRE! The power cord must not be pinched or against a sharp edge. Secure cord to avoid
tripping or snagging to reduce risk of fire, electric shock or personal injury. Do not run cord under carpeting. Do
not cover cord with throw rugs, runners or the like. Arrange cord away from traffic area and where it will not be
tripped over.
WARNING: RISK OF FIRE! To prevent a possible fire, do not block air intake or exhaust in any manner. Do not
use on soft surfaces where openings may become blocked.
WARNING: RISK OF FIRE! Do not place insulation against the fireplace.
WARNING: This electric fireplace is tested and listed for use only with the approved optional accessories. Use
of optional accessories not specifically tested for this electric fireplace could void the heater warranty and / or
result in a safety hazard.
WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result
causing property damage, personal injury or death. Do not store or use gasoline or other flammable vapors in the vicinity
of this or any other heater
Installation Overview :
Site Selection
Your new fireplace may be wall mounted, installed into existing framing or built into a wall. Review and consider all of the
following conditions for installation:
1. Fireplace dimensions.
2. Unit requires a minimum of two wall studs in order to ensure a secure installation.
3.
There are two possible installation methods: built-in or wall-mounted.
Note: A 15 Amp, 120 Volt circuit is required. A dedicated circuit is preferred but not essential in most cases.
6