Cleaning The Brewing Unit; Easy Cleaning" Programme - Melitta CI Touch Operating Instructions Manual

Care and maintenance

9.3 Cleaning the brewing unit

To avoid damage to the appliance, we
recommend cleaning the brewing unit
once a week.
Fig. 13: Removing the side panel
Fig. 14: Removing the brewing unit
Fig. 15: Cleaning the brewing unit
46
Mel_009_CI_Touch_20_de--kr_druck.indb 46
Requirement: The appliance is switched
off.
1. Open the cover (12). To do this, reach
2. Press and hold the red lever (33) on the
12
3. Pull the brewing unit out of the appli-
4. Rinse the entire brewing unit thor-
5. Allow the brewing unit to drip dry.
6. Use a soft, dry cloth to remove coffee
7. Insert the brewing unit into the appli-
15
8. To do this, insert the cover sideways
9.4 "Easy Cleaning" programme
The milk system is rinsed using the
33 Easy Cleaning programme.
Each time after a beverage has been
prepared with milk, the appliance requests
you to run the Easy Cleaning programme.
The Easy Cleaning programme can also be
run manually.
34
Requirement: The appliance is ready for
operation.
1. Place a vessel beneath the outlet.
2. Press the "rotary switch" for 2 seconds.
3. Navigate to the Care > Easy Cleaning
4. Select Start and confirm your selection.
5. Follow the further instructions on the
into the recess on the right of the appli-
ance and pull the cover off sideways.
brewing unit handle (15) and turn the
handle clockwise until it engages at the
stop.
ance by the handle.
oughly from all sides under running
water. In particular, make sure that
coffee residues are removed from the
sieve (34).
residues from the surfaces inside the
appliance.
ance. Press and hold the red lever on
the handle of the brewing unit and turn
the handle counter anticlockwise until
it engages at the stop.
until it engages.
» The menu appears on the display.
menu.
display up to the end of the Easy Clean-
ing programme.
14.09.2018 13:51:40