The Enable Security mode passwords are case sensitive.
Configure Telnet Access
The following steps show how to access the Telnet configuration parameters and change the
password. The default password for initializing a Telnet session is password (all lowercase). For
security purposes, change the password to something unique. For this example, replace the
underlined word with a password of your choosing. The NetVanta supports five Telnet sessions
(0 through 4).
1. Verify that the prompt of your unit displays (config)#.
2. Enter line telnet 0 4 to change the configuration parameters for the Telnet session.
3. Enter password word to change the login password for the Telnet session.
4. Enter exit to return to the Global Configuration mode.
An enable security mode password and Ethernet port parameters must be defined before
configured Telnet sessions are activated. Refer to
Parameters
information.
Save the Configuration
1. Verify that the prompt of your unit displays (config)#.
2. Enter exit to leave configuration mode.
3. Enter copy running-config startup-config to save the current configuration to memory. This
command may be abbreviated as copy run start.
4. Enter exit to close the configuration session.
Complete the Installation
The NetVanta is now configured and operational. Complete the installation by connecting the
appropriate cables to the serial and Ethernet networks. Please refer to your NetVanta Hardware
Installation Guide for more details on pinouts and cabling.
6
Set the Enable Security Mode Password
on page 2 and
Technical Support 1-888-4ADTRAN (1-888-423-8726)
Configure the Ethernet Port
on page 5 for
64200866L1-42C
Need help?
Do you have a question about the NetVanta Series and is the answer not in the manual?