Table of Contents
Advertisement
System Requirements
Connect the
1788-EN2DNROM Linking
Device to the EtherNet/IP
Network
The following hardware and software components are required to use the linking
device.
Required Hardware
• EtherNet/IP-to-DeviceNet linking device
• DeviceNet cabling, power, and devices forming a DeviceNet network
• Ethernet cabling
• Computer with USB connection or access to the Ethernet network
• 24V DC power to the linking device
DeviceNet power can be used; however, using DeviceNet power bypasses
the DeviceNet network isolation.
Required Software
• RSNetWorx for DeviceNet software, version 21 or later, to configure
DeviceNet devices and the linking device's DeviceNet functionality
• RSLinx® software, version 3.51 or later
• RSLogix
5000 software, version 20 or Studio 5000 Automation
™
Engineering & Design Environment™, version 21 or later
Connect the EtherNet/IP network cable to either of the two D-Code M12 ports
on the front of the linking device.
(View into connector 1)
5
1
Pin 1 M12_Tx+
Pin 2 M12_Rx+
4
2
Pin 3 M12_Tx-
Pin 4 M12_Rx-
3
Pin 5 Connector shell shield GND
EtherNet/IP D-code
M12 Connector
Rockwell Automation Publication 1788-UM059B-EN-P - September 2015
Install the 1788-EN2DNROM Linking Device
(View into connector 2)
3
Pin 1 M12_Tx+
Pin 2 M12_Rx+
2
4
Pin 3 M12_Tx-
Pin 4 M12_Rx-
1
Pin 5 Connector shell shield GND
5
EtherNet/IP D-code
M12 Connector
Chapter 2
17
Advertisement
Table of Contents
