Troubleshooting - Control 4 T4 Series Installation Manual

8 To install the charging station permanently into a table
or countertop, remove the small rubber discs covering the
threaded holes in the base.
9 Install the threaded posts (all thread) into the base of the
charging station.
10 Using the template and a 1/4" drill, drill two holes into the
surface where you are mounting the touchscreen. Maximum
surface thickness is 32 mm (1.25").
11 Mount the charging station assembly into the mounting
holes and secure it in place using a washer and nut.
5

Troubleshooting

To power cycle the touchscreen:
1 Press and hold the (power) button for at least 10 seconds
until the touchscreen turns off.
2 If it doesn't turn back on automatically, press and release the
(power) button again to turn it on.
To perform a factory data reset:
1 On the touchscreen's main screen, tap Settings, System Info,
then Factory data reset.
- OR -
If the touchscreen has not yet been configured, tap About,
then Factory data reset.
- OR -
To restore defaults without using the display
screen, press and hold the reset pinhole button
until "Erasing" appears on the screen.
Reset hole