Electric Connections - Riello BAG2 MIX Instructions For The Installer And The Technical Assistance Service

To form the electrical connections for the
cess must be obtained to the
card.
To gain access to the BAG
- Remove the front cover panel from the BAG
In the appliance you find connected:
- white cable for main supply
- black cable with 5 poles collector
- black bipolar cable with probs
In the envelopes you find:
- flat cable
- faston jumper
- probe wiring and thermostats
- PCB supply cable - 4 poles
If you decide to use cables other than those supplied,
cables with a 0,50 mm 2 section must be used. The length
of these connections must not exceed 15 metres.
CONNECTING THE ELECTRONIC SYSTEM CONTROL
BOARD (supplied) TO THE BOILER'S ELECTRONIC
BOARD
To form the connection, proceed as follows:
1. Remove the boiler's cover, open the back cover on the
control panel, as shown in the manual for the boiler.
2. Insert the BE08 board supplied (C) into its seating inside
the control panel, as shown in figure 2.
3. Connect the flat cable to the electronic system control
board and the electronic boiler control board (see photo
1 and the wiring diagram).
4. To provide power to the electronic system control board,
connect the cable's four-pole connector (supplied), as
shown in photo 2
Connect the prods to the mains power supply as shown in
fig. 3
Blue wire - neutral
Brown wire - phase
(see the wiring diagram)
photo 1
inside boiler
photo 2
inside boiler
BAG 2 MIX
2
BAG MIX and the boiler
2 MIX:
2
MIX.
outside boiler
outside boiler
, ac-
Fig. 1
Boilers from outside
Fig. 2

ELECTRIC CONNECTIONS

ELECTRIC CONNECTIONS ELECTRIC CONNECTIONS ELECTRIC CONNECTIONS ELECTRIC CONNECTIONS
Boilers from inside
C
C
outside boiler
outside boiler
INSTALLATOR
43