Installation Of The Appliance - Riello BAG2 MIX Instructions For The Installer And The Technical Assistance Service

INSTALLATION OF THE APPLIANCE

INSTALLATION OF THE APPLIANCE INSTALLATION OF THE APPLIANCE INSTALLATION OF THE APPLIANCE INSTALLATION OF THE APPLIANCE
2
The BAG MIX can be wall-mounted or "built-in", and can
be located near the boiler or at a distance, provided the
length of the plumbing and electrical connections between
the boiler and the BAG
2
The BAG MIX can be installed in positions exposed to
the weather (rain, sun, ice, etc.) only if in "built-in"
installation.
Note: The wiring supplied is 2 metres long.
In the case of installation of BAG
boilerss and electric connection on the lower side of
the unit, it is necessary that the wrinkled pipe comes
out of approx 10 cm.
Wall-mounted installation
2
When the BAG MIX is wall-mounted it must be supported
by two expanding wall anchors (supplied) that are suitable
for the type of wall and weight of the equipment.
We recommend using pipe sleeves built into the wall in
order to limit the infiltration of water.
These pipe sleeves are not supplied with the unit.
Electrical protection level IP10D.
"Built-in" installation
2
When the BAG MIX unit is built-in:
- Provide the building work, complete with a niche of
suitable size for the BAG
the wall (minimum indicative dimensions shown in the
figure).
- Position the BAG 2
open out the two support lugs to fix it more securely.
- Protect the side edges and front while building in the
device.
Since the plumbing and electrical connections between
the system and the BAG
the overall size of the device itself, first position the BAG
MIX and then the entry and exit pipes for the system and
the conduiting for the electric cables.
Electrical protection level IPX4D.
40
INSTALLATOR
2
MIX unit do not exceed 15 metres.
2 MIX with built in
2
MIX, to suit the thickness of
MIX in position, and remember to
2 MIX must be contained within
lug
2