Brewing Tea; Keeping Tea Warm - Beem Tea Joy Royal Plus Instruction Manual

ATTENTION: Water must not enter the base station (7)!
5. Push the on / off switch (6) down. The red signal lamps (5) light up.
6. The water boils very quickly. The on / off switch (6) switches off automatically and
the signal lamps (5) switch off.
Before you switch on the water boiler (1) again, let it cool down for 15 to 20 seconds. To
start the boiling process again, push the on / off switch (6) back down again.
6.2

Brewing tea

Hints and tips:
Thanks to the practical tea strainer (11) you do not need paper filters with this
appliance.
Your tea will taste best when the appliance is clean. Clean it regularly as described in
chapter 7.
Do not reuse tea leaves a second time as this will greatly impair the flavour of your tea.
1. Press the button (13) to open the lid (12)
2. Take the tea strainer (11) out of the tea pot (10).
3. Put either tea leaves or tea bags in it.
4. Replace the strainer (11) in the glass tea pot (10).
5. Boil fresh water with the water boiler (1) as described above.
6. Let the boiling water cool down for 30 seconds and pour it into the glass pot (10).
NOTE: Always be careful while handling hot water, in order to avoid burns.
7. When the tea has brewed for long enough, take out the tea strainer (11) and close
the lid (12).
ATTENTION: Do not cool the hot glass tea pot (10) down with cold water.
6.3

Keeping tea warm

Hints and tips:
Never use the glass pot to heat or boil cold water or other cold liquids. Only use the
water boiler to heat or boil cold water.
1. Switch on the keep warm plate (9) by pressing the on/off button (8).
ATTENTION: Do not leave the empty tea pot (10) on the switched-on keep warm
plate (9).
BEEM – Elements of Lifestyle
Seite/Page/Page/Página
20 / 60