Storage - Toro MB TX 2500 Operator's Manual

Storage

1. Shut off the engine and engage the parking
brake.
2. Remove dirt and grime from the external parts of
the entire machine, especially the engine. Clean
dirt and chaff from the outside of the engine
cylinder head fins and blower housing.
3. Service the air cleaner; refer to
Cleaner (page 19).
4. Grease the machine; refer to
Machine (page 19).
5. Change the engine crankcase oil; refer to
Changing the Engine Oil and Filter (page
6. For storage over 30 days, prepare the machine
as follows:
A. Add a petroleum based
stabilizer/conditioner to fuel in the
tank. Follow mixing instructions from
stabilizer manufacturer. Do not use an
alcohol-based stabilizer (ethanol or
methanol).
Note:
Fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Shut off the engine, allow it to cool, and
drain the fuel tank using a pump-type
syphon.
D. Start the engine and run it until it stops.
E. Choke the engine.
F. Start and run the engine until it does not
start again.
G. Dispose of fuel properly. Recycle as per
local codes.
Important:
Do not store
stabilizer/conditioned fuel over 90 days.
7. Remove the spark plugs and check the condition
of them; refer to Servicing the Spark Plugs
(page 22).
8. Prepare the engine as follows:
A. With the spark plugs removed from the
engine, pour 2 tablespoons of engine oil
into the spark plug holes.
B. Place a rag over the spark plug holes to
catch any oil spray, then pull the starter
rope to crank the engine and distribute the
oil inside the cylinder.
10.
11.
Servicing the Air
12.
Greasing the
21).
37
C. Install the spark plugs.
Note:
Do not install the wire on the spark
plugs.
9. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
Store the machine in a clean, dry garage or
storage area.
Cover the machine to protect it and keep it clean.