Toro MB TX 2500 Operator's Manual page 30

3. Release the cushion and remove the fuel tank;
refer to Removing the Fuel Tank (page
4. Raise the rear of the machine and support the
machine on jack stands.
5. Remove the skid plate
Figure 39
1. Rear bolt (2)
2. Skid plate
6. Remove the extension spring
7. Remove the 2 bolts and 2 nuts and loosen the
2 set screws on the coupler. Remove the gear
pump from the pump mount
Note:
You do not need to remove the fittings
from the pump.
Figure 40
1. Bolt (2)
2. Pump mount
8. Remove the drive belt from the engine pulley
and 2 transmission pulleys.
24).
(Figure 36).
g203662
3. Side bolt (4)
(Figure 38).
(Figure 40).
g189559
3. Gear pump
4. Nut (2)
1. Engine pulley
2. Idler pulley
9. Route the new belt around the engine pulley and
2 transmission pulleys
10. Install the gear pump
11. Install the extension spring
12. Install the fuel tank; refer to
Tank (page 24).
13. Raise the cushion.
29
Figure 41
3. Transmission pulley (2)
4. Belt
(Figure 41).
(Figure 40).
(Figure 38).
Removing the Fuel
g189571