Connecting The Trpp 5810 Unit; Figure 2-1 Trpp 5810 Connection Diagram Label - Olympus TRPP 5810 User Manual

DMTA-20070-01EN, Rev. A, October 2014
2.2

Connecting the TRPP 5810 Unit

The connectors for the probes are located on the front of the TRPP 5810 unit. The
POWER input connector and the connectors that interface with the acquisition unit
are located on the back of the TRPP 5810 unit.
Refer to the label affixed to the bottom side of the unit for an illustration of the
common connections to the product (see Figure 2-1 on page 20).
To
P1
Out
To
P2
Out
To prevent the risk of electric shock, the product must be connected according to the
manufacturer's instructions.
To connect the TRPP 5810 unit
1. Connect the pulser probes to the P1 OUT and P2 OUT connectors.
2. Connect the receiver probes to the R1 IN and R2 IN connectors.
20 Chapter 2
TRPP 5810 connection diagram
Probes

Figure 2-1 TRPP 5810 connection diagram label

CAUTION
Acquisition unit
From
R1 Out
To
R1
From
In
R2 Out
To
To
R2
P1 In
In
To
P2 In
To acquisition
unit receiver
inputs
From acquisition
unit transmitter
outputs