Operations; Weighing; Taring; Pre-Tare Function - Baxtran AND200A User Manual

ANF-AND-ANG
Mul•-func•onal balances
4 . O P E R A T I O N S
KEY FUNCTION
ON/OFF
Turn on/off power of the balance
FUNCTION
Call up menu (keep key pressed un!l UNIT appears)
- Confirm se#ngs in the menu.
SET/TARE - Save and exit menu.
- Tare weight.
- Select weighing unit.
UNIT/COUNT
- Change se•ngs in the menu.
- Parts coun•ng.
- Display hold.
HOLD/PRINT - Calculate weighing data via interface.
- Change se•ngs in the menu.
ZERO Zero balance.
4 . 1 . W E I G H I N G
> Turn on the balance using the
> The balance will perform self-test for few seconds. When the zero display appears, the balance is
ready for operations.
Important: If the display not showing zero, press the
> Place objects onto the center of pan. Take care that the weighed material should not touch the
balance housing.
> Now the weight is displayed. Once the reading is stable, the weighing unit (e.g.
on the right-hand side of the display.
> If the objects are heavier than the weighing capacity, the display will show
4 . 2 . TA R I N G
> Turn on the balance using the
> Put the tare vessel on the weighing plate and press the
zero. The weight of the vessel is now saved.
> The taring process can be repeated any number of times, e.g. when adding several components for a
mixture (adding).
> The limit is reached when the total weight reaching full capacity of the balance. After removing the
taring vessel, the total weight is displayed as negative reading.
> After finishing the weighing process, press the
ZERO
.
4 . 3 . P R E • TA R E F U N C T I O N
Using this function the weight of a tare vessel can be stored.
This value also remains saved if the balance meanwhile has been switched off and switched on again.
> Turn on balance using the
> Put tare vessel on the weighing plate. Press the
> Press the
UNIT/COUNT
the current weight on the weighing plate is saved as PRE-Tara weight.
> To switch off this function, unload the weighing plate. Press
> Press the
UNIT/COUNT
> Press the UNIT/COUNT
the stored PRE-Tare weight is deleted.
User's guide
key.
ON/OFF
ON/OFF OFF key and wait for the
SET/TARE
key and wait for the zero display.
ON/OFF
PtArE
key 6 times until flashes on the display. By actuating the
key until balance displays
PtArE
key 6 times until flashes on the display. By actuating the
key.
ZERO
ZERO
display.
key. The balance display goes to
SET/TARE.
key again, the balance display goes back to
UNIT/COUNT key until balance displays
key if display is not showing zero.
ZERO
5 PCS
.
ENG FR ES
g kg
or ) will appear
Error
(=overload).
5 PCS
.
key,
SET/TARE
SET/TARE key,
25