Yamaha XP500 2002 Supplementary Service Manual page 12

C Fasten the starter motor lead, battery negative
lead, V-belt reset coupler, and seat lock cable to the
frame with a plastic band.
Position the band clasp on the bottom of the frame
and face the band end to the outside.
D Fasten the fuel sender lead and fuel pump lead to
the frame with a plastic clamp.
Route the fuel sender lead through the back of the
fuel pipe and pass it through the clamp from the
backward of vehicle. (Cross the leads in the
clamp.)
E Place the wireharness and seat lock cable in the
frame holder.
F After adjusting the adjustment nut, attach the front
and rear parts of the boot tightly. After placing the
boot, install the fuel hose to the frame guide.
CABLE ROUTING
G Through the seat lock cable between wireharness
and frame.
H Use the clamp on the back of the frame to hold the
side stand switch lead and fan motor lead.
I Connect the wireharness (wire taped area) to the T
stud of frame.
J After connecting the main switch lead, push it be-
tween the seat lock cable adjustment area and the
frame.
K Through the main switch lead between frame and
seat lock cable.
L After connecting the wireharness and meter lead,
use a plastic clamp to connect them to stay 1.
M Connect to the headlight sub harness (left and
right)
–6–
SPEC