Garland BEST 310 DPG Instruction Manual page 37

7.2.1. CUTTING METHOD:
1. Cut with the left front of the disc
2. Corte Always cut to the left keeping the disc
slightly inclined to the left.
IMPORTANT:
- Only use this machine to cut grass. Do not let
the disc touch materials that can not cut as stones,
metals, hard wood, wire mesh, etc.
- Keep the blade sharp. A bad sharpened disc cause
a higher cutting force on the machine as well as
increased risk of rebound or projection materials.
- Keep the area to be cut clean with no traces of
chopped vegetables or other materials.
8. MAINTENANCE AND SERVICE
It is necessary to always turn off the engine and
check that the cutting tool is stopped before cleaning,
transporting or modify the cutting tool.
Keep clean the machine, especially the fuel tank area
and areas near the air filter.
Never try adjustments in the machine if it is running
and / or attache to the user by the harness. Perform
all maintenance of the machine when is set on a flat
and clear surface.
Use only suitable spares to get a proper performance
for this machine. This replacement can be found on
the official distributor of the machine. Using other
sparks may causes risks, damage to the user or
people around the machine.
Before performing any maintenance or repair the
machine make sure the engine is off and remove the
spark plug cap.
Make periodic inspections of the machine to ensure
that the machine is correct. For a thorough inspection
take the machine to your dealer.
Air filter
- The dirt in air filter will cause a reduction in
machine performance. Check and clean this
element. If you notice damage or alterations
replace it with a new filter.
Carburetor adjustment
- Carburetor adjustment is complicated and should
be done only by the service.
Fuel filter
- The fuel tank is equipped with a filter. It is at the
end of the suction pipe and can be removed with
the help of a hook of wire.
- Check the fuel filter regularly. Do not allow dirty
in the fuel tank to prevent the filter is dirty. A dirty
filter will make it more difficult to start the engine
and cause malfunctions or stop it.
- Check fuel. If you see dirty replace
- If the inside of the fuel tank is dirty you can clean it
with gasoline.
Check the spark
The most common problems when starting a machine
are produced by a dirty spark plug or bad. Clean spark
plug and check it regularly. Check the electrode gap is
correct (0,6 - 0,7 mm).
37/132
English