Garland BEST 310 DPG Instruction Manual page 34

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 24
English
Mix gasoline and oil in a bottle homologated for this
use.
Do not smoke while preparing or refueling.
Do not approach any flame or hot element
to the fuel.
Do not unscrew the combustible tank cap while the
engine is running.
While filling the tank make sure the engine is off and
cold. Do not refuel while the engine is running or hot.
In case of combustible spill clean the entire area with
the help of a cloth.
Do not ever make this in a closed or poorly
ventilated place.
Store fuel in a bottle or tank homologated and
according to current regulations.
If you will mix more combustible just prepare the
amount you will use the short term. Do not use
fuel that has been stored over two months. The
fuel stored for long periods lose its characteristics
making it harder to start the engine and giving poorer
performance.
6.3.2. FILLING THE FUEL TANK
1. Choose an open are ato perform this situation
2. Stay away from the area where you have made the
preparation of the mixture.
3. Remove the combustible tank cap and fill with
fuel mixture without completing the full.
4. Close tighly the fuel cap and remove all traces of
fuel that have been spilled with a rag.
WARNING: Always switch off the engine before
refueling.
Do not perform this operation in an enclosed or
poorly ventilated.
Stay away at least 3 meters from the zone
where you have refueled before started the
machine.
6.4. START UP
6.4.1. START UP IN COLD
1. Move the air lever (e) to the cold start position.
2. Place the switch (a) in the position ¨I¨ (start).
3. Press the primer bulb several times (f) (7 to 10
times) until the fuel reaches the carburetor.
4. Press the security button (b) and after that press
the accelerator trigger (c).
5. Pull the starter rope until you hear the engine start.
6. Move the air lever (e) to the normal
working position.
7. If the engine exploded but did not actally start
running, pull the start rope again until it starts.
Allow the engine to warm up for approximately one
minute before starting to work with the machine.
34/132
.

Advertisement

Table of Contents
loading

Table of Contents