Ei Power Pack Connection; Ei Salt Chlorinator Parametering; Ei Power Pack Description - Zodiac EI Installation And User Manual

3.4 Ei power pack connection

The Ei Zodiac appliance is designed to operate only with a 220-240 Vac 50 Hz. power supply. The Ei Zodiac appliance is designed to operate only with a 220-240 Vac 50 Hz. power supply.
!
IMPORTANT: The installation and use of Ei salt water chlorinators must comply with the instructions and
recommendations presented in this manual. For additional information, please contact your professional
pool retailer.
The Ei chlorinator may be connected in two different ways:
1) Either connected to a permanent power supply using the plug (power supply protected by a 30 mA
ground fault switch in compliance with NF C15-100 or equivalent depending on each country).
2) Either directly subjected to the pool fi lter system (appliance only connected when the fi ltering is
operational).
Le fi rst possibility above is the preferred electric connection.
Once the connections are completed successfully and glue (if any) has set and dried (wait a few
hours depending on the product used), connect to the electrical mains in order to operate the Ei.
4

Ei salt chlorinator parametering

4.1 Ei power pack description

The diagram below shows the functions of your Ei appliance power pack:
1 LCD screen
2 Chlorine production visual indicator (1
and 4 others green)
3 Red visual light 'Flow' lack of fl ow safety
4 Adjustment of chlorine production button
5 'Salt' lack of salt orange indicator
6 Hours setting button
7 Clock adjusting button
8 Minutes adjusting button
9 button manual "on/off"
10 programmer button
11 reset button
EN
st
orange
25