Advertisement
36
37
33
30
32
35
34
Way 2: work with dual handle deck mount bath faucet
Put the washer(30) into the nut(32) of the tee(31). Then connect the tee(31) to one side body(33) of the deck mount
bath faucet.
Put the fiber washer(34) into the nut(35). Tighten the nut to one of the ports of the center tee(36) for the spout.
Connect one side body(37) and tee(31) on another side body with hose(28, length: 1000mm).
Connect the tee(31) and bottom port of the diverter with one of the hoses provided with deck mount faucet(Remove
another hose and put it away). Connect the shower hose(26, length: 2000mm) and shower end(the end with check
valve(13)) of the diverter with connection hose(29, length: 600mm).
Connect the center tee(36) and another end of the diverter with hose(27, length: 1000mm).
To ensure the water flows smoothly and the handshower can be drawn out easily, the hose should avoid kinking,
twisting. To ease installation, you may back off tee of the spout up to 180 degree. NOTE: Hoses should be only
used where indicated.
INSTALLATION CHECKOUT
Ensure all coupling nuts are tight. Turn on main water supply and check for leaks. Repair as required.
1332564-2A-B
31
28
27
13
26
29
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
4
1332564-2A-B
How to Maintain the Handshower
Any debris or mineral build-up may cause
the flow stream distorted or reduce the flow
rate. To remove the debris or mineral
build-up, run water through the handshower,
firmly press or rub your finger back and forth
across the rubber nozzles.
Remove and clean the screen washer.
5
Advertisement
