Test Mode - Airstream EXPERT 2V3SA User Manual

EXPERT 2V3SA
1. From the main menu, select: CLEAN
MODE.
Status: Off
Setp: 45.0°F
End of clean
delay: 15min
Use minimum
vent.? No
Detect low
temp. ? No
2. Set the following parameters:
(The parameter adjustment process is explained
in section 3.2 on page 8).
Status — Select "On" to enable the clean
mode or select "Off" to disable it.
Clean mode set point — Select what is
the target room temperature while the
controller operates in clean mode.
End of clean delay — At the end of the
clean mode, the controller waits a certain
time before monitoring temperature alarms
again. Specify the time required for the
room temperature to get back to normal
or select "Off" to disable this function
(decrease the parameter value until letters
"Off" are displayed).
Use minimum ventilation? — Select "Yes"
to activate minimum ventilation cycles
while the clean mode is on.
Detect low temperature? — Select "Yes"
to enable the low temperature alarm
limit or select "No" to disable this alarm
condition.
16
EXPERT 2V3SA, rev.10
4.6.

Test Mode

A test mode allows you to simulate tem-
perature changes and verify controller perfor-
mance. In test mode, the room temperature
probe inputs are turned off, allowing the user
to change the temperature used by the con-
troller to operate the stages. The controller
operates as before using the new temperature
settings.
The test mode is used to simulate tempera-
ture changes in order to verify the controller's
performance. The temperature probe inputs
are turned off while the test is on and the
test automatically ends after 15 minutes of
inactivity.
1. From the main menu, select: TEST.
2. Use the navigation keys to select the fol-
lowing parameters:
Test Mode
Off
Room T° bypass:
78.0°F
3. Set the following parameters:
(The parameter adjustment process is explained
in section 3.2 on page 8).
Test Mode Status — Select "Yes" to enable
the test mode or select "No" to exit from
the test mode.
Temperature — Enter the simulated room
temperature. *This parameter can only be
changed when the test mode is enabled.