Rossmax RA500 Quick Manual

Rossmax Thermometer RA500
Quick Guide

How to use the RA500 Infrared Ear Thermometer

1. To achieve accurate readings, make sure the ear canal is clean.
2. Press the "On/Off/Memory" bu�on. The thermometer is ready for use a�er the ear icon is flashing and two beeps
are sounded.
3. Gently pull the ear back to straighten the ear canal and snugly posi�on the probe into the ear canal, aiming towards
the membrane of the eardrum to obtain an accurate reading.
4. Measuring the ear temperature: Use the index finger to trigger. Press "Start" bu�on, a long beep will be sounded
when measurement is done.
5. Power Off: Device will automa�cally shut off if le� idle for more than 1 minute to extend ba�ery life. Or press
"On/Off/Memory" bu�on for at least 3 seconds to turn the device off.
6. Fever alarm: the measuring temperature is higher than 37.5°C (99.5°F), the display will flashing and 4 short beeps will
be sounded. The measuring temperature is higher than 42.2°C (108.0°F), the display will show "Hi"and 4 short beep will
be sounded.
a. It is recommended that you measure 3 �mes with the same ear. If the 3 measurements are different, select the
highest temperature.
b. To avoid the risk of cross contamina�on, please clean the probe according to "Clean and Storage" sec�on a�er each
use.

Scanning Mode

If you con�nuously obtain different measurement results, it is recommended that you use Scanning Mode to
measure.
Measuring the ear temperature: Use the index finger to trigger, press and hold the "Start" bu�on for 3 seconds
to take measurement. During the measuring process, gently pivo�ng the probe side-to-side to view the en�re
ear canal in order to find the highest temperature. Release the "Start" bu�on un�l hearing a long beep sound
and the measurement is completed.
Remarks: Please consult your doctor for the interpretation of results and diagnosis.
For a�er sales service, please contact Cypress Medic Sdn Bhd (www.cypressmedic.com.my)