Rossmax RA600 Quick Manual

Rossmax Thermometer RA600
Quick Guide

How to use the RA600 Infrared Ear Thermometer

To achieve accurate readings, make sure a new, clean probe cover is in place before each measurement
1.
and the ear canal is clean.
a. Install the probe cover by clockwise rotating then fix it.
b. Remove the probe cover by anti-clockwise rotating then releasing it.
2. Press the "On/Off/Memory" button. The thermometer is ready for use after the ear icon is flashing and two beeps
are sounded.
3. Gently pull the ear back to straighten the ear canal and snugly position the probe into the ear canal, aiming towards
the membrane of the eardrum to obtain an accurate reading.
a. Before measurement, correct installation of the probe cover ensures accurate measurement.
b. Replace the probe cover after each use to ensure an accurate reading and avoid cross contamination.
c. This thermometer must only be used with Rossmax probe covers, other covers can lead to inaccuracy.
If running out of probe covers, please contact with the original seller or distributor for buying new
probe covers.
4. Measuring the ear temperature: Use the index finger to trigger. Press "Start" button, a long beep will be sounded
when measurement is done.
5. Power Off: Device will automatically shut off if left idle for more than 1 minute to extend buttery life. Or press
"On/Off/Memory" button for at least 3 seconds to turn the device off.
6. Fever alarm: the measuring temperature is higher than 37.5°C (99.5°F), the display will flashing and 4 short beeps
will be sounded. The measuring temperature is higher than 42.2°C (108.0°F), the display will show "Hi"and 4 short
beep will be sounded.
a. It is recommended that you measure 3 times with the same ear. If the 3 measurements are different, select
the highest temperature.
b. To avoid the risk of cross contamination, please clean the probe according to "Clean and Storage"section after
each use.
For after sales service, please contact Cypress Medic Sdn Bhd (www.cypressmedic.com.my)