Rossmax HA500 Quick Manual

Temple thermometer

Hide thumbs Also See for HA500:

Rossmax Temple Thermometer HA500

Quick Guide

How to measure temple temperature

1. Always make sure the probe is clean, and without damage.

2. Press "ON/OFF/Memory" button to power on the device.

3. Vertically aim the thermometer at the temple with a distance of less than 5 cm. If the temple is

covered with hair, sweat or dirt, remove the obstacle from the temple to improve the measuring

accuracy.

4. Press the "Start" button to take temperature. Measurement is complete when you hear a long

beep sound.

5. Read the recorded temperature from the LCD display.

6. Clean the probe after each use to ensure an accurate reading and avoid cross contamination.

(See the section of Care and Cleaning for details.)

7. Remember to put in the storage case when not in use.

Remark: Please consult doctor for interpretation of results

For after sales service, please contact Cypress Medic Sdn Bhd (www.cypressmedic.com.my)

For switch mode,

1. Turn "OFF" the device

2. Hold "START" button for more than 8

seconds

Table of Contents

Do you have a question about the HA500 and is the answer not in the manual?

Page 1 Rossmax Temple Thermometer HA500 Quick Guide How to measure temple temperature 1. Always make sure the probe is clean, and without damage. 2. Press “ON/OFF/Memory” button to power on the device. 3. Vertically aim the thermometer at the temple with a distance of less than 5 cm. If the temple is covered with hair, sweat or dirt, remove the obstacle from the temple to improve the measuring accuracy.
Page 2 Caution 1. Only use the device once you have read and understood these instructions for use. Keep the instruction manual for use. 2. The thermometer and patient needs to stay in the room in which the measurement is taken for at least 30 minutes before use.