Table of Contents
Advertisement
Test Jack Configuration Screen
The Test Jack Configuration screen
back of the QDFR unit. This jack can "look at" a chosen port, in either direction as chosen by
the user, as if it were a monitor jack (non-intrusive mode) or it can "break" a chosen port, in
either direction, as if it were a equipment jack (intrusive mode).
Shelf:
1
The options on this screen are as follows:
• Toggle Test Jack Mode – Select Monitor (non-intrusive) or Terminate (intrusive)
• Change Test Port Number – Select an active port
• Toggle Inclusive Test Direction – This option has no effect on Monitor mode. Select Network
or Customer
Refer to
"Appendix
ality of the test jac
61181307L7-5E
(Figure
Slot:
2
Total Access System
Test Jack Configuration Screen
-----------------------------------------------------
Test Jack Mode:
Active Port Number:
Intrusive Test Direction:
1.
Toggle Test Jack Mode
2.
Change Test Port Number
3.
Toggle Intrusive Test Direction
Selection:
Figure 11. Test Jack Configuration Screen
B",
"Rear Panel DS1 Test Access"
k.
11) controls the test jack, which is found on the
Monitor
Port 1
Network
or a full description of the function-
f
Menu Descriptions
mm/dd/yy hh:mm
13
Hide quick links:
Advertisement
Table of Contents
