Normal Operation; Basic - Image Industries Smartweld SW1200 Operation Manual

Section 3
Controls Diagram
Some features shown are optional.
Screen Conventions
 
  
  

Display Backlighting
To extend display life, the backlight will turn off after a few minutes. This is normal. The next button push or knob
turn will light the backlight again.
home Screen
 

 
screen may be locked. Check unlocking screens later in the manual for additional information.
Line 1 Welder Function
Line 2 Data Line Controlled by Upper Rotary Knob
Line 3 Data Line Controlled by Lower Rotary Knob
Line 4 Information
(Maintenance Required, more info on next screen, locked/unlocked)
The "Home" screen is either the Normal Operation screen or the Auto weld
screen depending on the selected mode. To weld the home screen must be
showing. You can always reach this screen (except when entering a password,
changing a password or when you are in an error screen) by depressing the
home button on the front panel. If the welder is left in some other screen the
unit will automatically return to the home screen after a short time. Note: This
1

Normal Operation