Table of Contents
Advertisement
Section 4
Clearing errors:
To clear an error press the
before the error can be cleared.
Adjusting the Time and Date
the day and year. Pressing the
Capturing Output Data
Once installed, the data recorder module will ALWAYS report weld data. If weld data is not required, the printer
port can be left unconnected.
The data is not saved in any way and must be captured by some device after every weld. The 9 pin male connector on the
front panel must be connected to an appropriate device to capture data. A serial printer (verify with printer manufacturer)
with a standard serial cable or a lap-top running a terminal program with a null modem cable can be used to capture output.
Changing Data Rate
BAUD RATE:
Data Bits:
Stop Bits:
Parity:
reset button on the front panel. If the error screen is locked, it must be unlocked
Press the
(and AM/PM ) will start to flash. Either rotary knob will adjust the hour. This
setting also adjusts AM/PM by adjusting the hour before or after 12:00. Press
the
knob will adjust the minute.
By pressing the
rotary knob will adjust the month up or down. Repeat this procedure to adjust
scroll down button again brings up the Printer Speed (BAUD Rate) screen.
The top rotary knob will change the welder's output BAUD rate. If the lower
left corner of the Printer Speed screen displays the lock symbol then the
Printer Speed can not be changed without entering the unlocking code. (See
Code Section for details on entering the code). Pressing
returns the display to the Limit:Current screen.
9600/4800/2400/1200
8
1
None
Optional features
scroll right button to activate the time change mode. The hour
scroll right button again and the minute will flash. Again, either rotary
scroll right button again the month will start to flash. Either
scroll down again
Advertisement
Table of Contents
