Image Industries Smartweld SW1200 Operation Manual page 21

Section 3
feATURe LOCKING
 
 

From the home screen press the
Locking Screen is always locked even if the user code has been entered in another screen. To access this menu, the user
must unlock it with the user code.
Once unlocked, the upper rotary knob selects one of 3 options:
Option 1: All Locked. All Features are locked and require the entry of a user code to adjust values.
Option 2: All Unlocked. No Features are locked.
Option 3: Selective Locking. Some Features are locked and require entry of a user code to adjust values.
SeLeCTIVe feATURe LOCKING
 
 

  
Home
Gas Mode
Each feature can be individually locked or unlocked to prevent unauthorized adjustment. Some features are optional. If that
optional module is not installed, you will not see the choice to lock/unlock that feature.
eRROR RePORTING
 


This function allows restricted access to none, some or all of the power supply's
advanced features. This is beneficial for many circumstances:
• For companies trying to establish an ISO9000 style program this prevents
unauthorized changes to the set up.
• If 0.5 seconds of gas pre-flow time is programmed the unit can prevent
operator adjustments to that time value.
• Prevents changes to advanced features, like pilot arc, which should only be
changed by experienced operators.
• Prevents conflicts between shifts. If a Memory Preset has been
programmed by a 1st shift operator, the Memory Preset may be over
written by a 2nd shift operator. If the Memory Preset feature is locked
then this conflict is prevented and can be controlled by a supervisor.
scroll down button 5 times to access the Feature Locking screen. Note: The Feature
The first item that comes up under Selective Feature Locking is the Maintenance
Counter. Turning the lower rotary knob will change the (Maintenance) Counter
Lock from Locked to Unlocked and back again.

To adjust other features press the
will come up in order (if available):
Maint Counter
Limits
Starting at the home screen press the
the error reporting screen. If the last row of the Error Screen displays the à lock
symbol the feature can not be reset with out entering the unlocking code (See
Code Section for detail on entering the code). To unlock this screen you must

enter the user password.
This feature only applies to the manual stud welding mode. In the automatic
Normal
Pilot Arc Hammer Mode
Preset Error
1
Operation
scroll right button. The following features
Language
scroll down button 6 times to reach