Image Industries Smartweld SW1200 Operation Manual page 19

Section 3
ReVIeW LAST WeLD ReSULTS
 

 
 
MAINTeNANCe COUNTeR
 
 
 
    
the actual welds since the last maintenance interval are greater than or equal to the maintenance alert set point the message
"! Maintenance" flashes across the bottom line of the Home Screen.
When this occurs, the counter can be reset from the Maintenance Screen. If the last row of the Maintenance Screen displays
the  lock symbol the feature can not be reset with out entering the unlocking code (See Code Section for detail on entering
the code). Once the screen is unlocked the alert can be cleared by pressing the reset button
unlocked, the set point is changed by the upper rotary knob. This value changes by 100's. If desired, this feature can be
turned off by turning the knob to the left until "OFF" is displayed.
Suggested Uses
This feature can be used in conjunction with preventative maintenance programs. It can be used for many purposes.
Some suggestions might be:
- Blowing dust out of the power supply
Total Lifetime Welds
 
 

This feature confirms that the weld results are consistent with the settings that
have been selected. To see the actual time and current results of the last weld
press the
main weld current and main weld time for the previous weld. Pressing the
scroll right button again returns you to the Home screen. When using Auto

Weld, data is reported in Amps and Energy (Watt•Seconds).

Note: Due to many factors these values may not EXACTLY match your settings.
Results within a few percent of your settings are normal.
This feature allows the operator, shop supervisor or maintenance department
to track service intervals. Tracking service intervals allows maintenance to be
skipped when not required or calls attention to maintenance requirements when

they are due.

From the Home Screen pressing the
the maintenance screen. This screen shows the actual welds since the last
maintenance interval. This also shows the maintenance alert set point. When
- Cleaning/Servicing Stud Weld tool
While in the maintenance screen, pressing the
will show the number of welds since the power supply was built up to a
maximum of 4 billion welds.
Normal
scroll right button. This shows the actual measured values for
1
Operation
scroll down button once displays
on the front panel. Once
- Changing Weld Chucks
scroll right button