PART NUMBERS COVERED BY THIS MANUAL
Part Number
80026*
50776, 50777, 50778*, 50779*, 50780*,
80022*
80023*
80031
80029
50776, 50777, 50781, 50797, 50798, 50799
80032
*
- currently obsolete part numbers
INTRODUCTION
This manual covers the setup and use of the Norbar hydraulic tool test system. The Calibration fixture is
designed to be used with the correct Norbar calibrated static transducer to test inline ratching hydraulic
torque wrenches.
SAFETY
IMPORTANT:
DO NOT OPERATE THE SYSTEM BEFORE READING THESE INSTRUCTIONS.
FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY OR DAMAGE TO THE
TOOL UNDER TEST.
Isolate the tool from all energy sources before changing or adjusting the drive square or socket.
There is a risk of crushing between the reaction bar and work piece.
Keep hands away from reaction bar.
Keep hands away from tool output.
Keep loose clothing, hair, etc. from being caught in any rotating part of the tool.
Use only sockets and adaptors which are in good condition and are intended for use with power tools.
Read operating instructions for hydraulic tool.
Read operating instructions for transducer and measurement instrument.
2
To Fit Transducers
50703, 50704, 50599, 50630, 50699*
50781, 50797, 50798, 50799
50782, 50783
50703, 50704, 50599, 50630
50782, 50783
Drive Square
Maximum Torque
1 ½"
7,000 N∙m
2 ½"
50,000 N∙m
3 ½"
80,000 N∙m
1 ½"
7,000 N∙m
2 ½"
50,000 N∙m
3 ½"
80,000 N∙m