Input Power Connections; Control Supply Connector; Figure 2-1: Control Supply Connections; Table 2-1: Control Supply Wiring Specifications - Advantech Automation1 XC4 Hardware Manual

2.1. Input Power Connections

2.1. Input Power Connections
The XC4 has two AC input power connectors. One connector is for control power and the other
connector is for motor power. For a full list of electrical specifications, refer to
to Section 2.10. for a System Interconnection Drawing.

2.1.1. Control Supply Connector

The Control Supply input supplies power to the communications and logic circuitry of the XC4 . The L
input is connected to an internal fuse. Refer to
The N input is not connected to an internal fuse. An external fuse will be required if N is not connected
to Neutral.
The Control Supply contains an internal filter but you could be required to add an external filter for CE
compliance. Install the external filter as close as possible to the XC4. Use a Schaffner FN2080 filter, an
Aerotech UFM-ST noise filter module, or equivalent device.
IMPORTANT: Refer to local electrical safety requirements to correctly size external system
wires.
Table 2-1: Control Supply Wiring Specifications
Pin Description
L Line (L): 100-240 VAC Control Power Input
Neutral (N) or 100-240 VAC Control Power Input with external
N
fuse
Protective Ground
Table 2-2: Mating Connector Part Numbers for the Control Supply Connector
Type
3-Pin Terminal Block
28
Table 5-4
Figure 2-1: Control Supply Connections
Aerotech Third Party
P/N P/N
ECK00213 Phoenix 1754465
XC4 Hardware Manual
Section
for the internal fuse value and part number.
Recommended Wire Size
0.8 mm
0.8 mm
0.8 mm
Screw
Torque: N·m
0.5 - 0.6
1.1. Refer
2
(#18 AWG)
2
(#18 AWG)
2
(#18 AWG)
Wire Size:
2
mm [AWG]
3.3 - 0.516 [12-30]
www.aerotech.com