SAN I/O Module specifications
This appendix provides product specifications and regulatory compliance as a handy reference.
Access Gateway Mode default port mapping
The 4424 SAN I/O Module can contain 24 total ports. Of these, F_Ports are ports 1-16 and N_Ports
are ports 0 and 17-23.
In Access Gateway mode, the SAN I/O Module F_Ports are mapped to N_Ports. This following lists
the factory-default F_Port to N_Port mapping for Access Gateway mode. Since the SAN I/O Module
is shipped with Dynamic Ports on Demand (DPOD) enabled, any out of the 24 ports can be
enabled. Therefore this mapping applies for 12 active ports or, if POD licensing is enabled, for 24
ports. For more information on changing port mapping and managing ports in Access Gateway
Mode, refer to the Access Gateway Administrator's Guide.
•
•
•
•
•
•
•
•
•
•
Processor and memory specifications
The processor and memory installed in the SAN I/O Module are shown in
TABLE 5
Memory Type
PowerPC 440GP processor
SDRAM
Boot flash
Compact flash
4424 Blade Server SAN I/O Module Hardware Reference Manual
53-0000571-01
17-20 as N_Port with failover enabled, failback enabled
0, 21-23 as N_Port with failover enabled, failback enabled
1, 2 mapped to 17
3, 4 mapped to 18
5, 6 mapped to 19·
7, 8 mapped to 20
9, 10 mapped to 21·
11, 12 mapped to 22·
13, 14 mapped to 23·
15, 16 mapped to 0
Memory Specifications
Value
333 MHz
256 MB - for system memory at 64 bits wide with
8 ECC bits
4 MB
256 MB
Appendix
A
Table
5.
25