Using The Cmc Gui To Set The Ip Address - Brocade Communications Systems BROCADE 4424 BLADE SERVER 53-1000571-01 Hardware Reference Manual

2
Modify the SAN I/O Module IP address
3. At the login prompt, log in to the SAN I/O Module. The default user name is "admin" and the
4. Use the appropriate CLI commands to change the IP address of the selected SAN I/O module.

Using the CMC GUI to set the IP address

To change the IP address, use the following steps:
1. Open the CMC application's Setup tab.
2. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate
3. To enable DHCP, select DHCP Enabled and click Apply.
FIGURE 4
NOTE
Refer to the documentation for the CMC GUI application for additional detail.
12
•
Switch-3 for SAN I/O Module installed in bay B1.
•
Switch-4 for SAN I/O Module installed in bay B2.
•
Switch-5 for SAN I/O Module installed in bay C1.
•
Switch-6 for SAN I/O module installed in bay C2.
password is "password".
Refer to your Blade Server Enclosure CLI documentation.
and click Apply.
CMC Setup Tab
4424 Blade Server SAN I/O Module Hardware Reference Manual
53-0000571-01