Table of Contents
Advertisement
2
Changing from Fabric Switch mode to Access Gateway mode
Web Tools
Complete the following steps to enable Access Gateway mode using Web Tools.
1. From the management console, open a Web browser.
2. Enter the IP address of the SAN I/O Module into the Address field of the Web browser.
3. Log into Web Tools using the default administrative account.
4. From the Fabric Tree, select the SAN I/O Module.
5. Click the Switch Admin button in the WebTools Manage taskbox.
NOTE
You should save the configuration file if you are converting an SAN I/O Module to Access Gateway
mode. To save your current configuration, click the Show Advanced Mode button in the top
right-hand corner of the Switch Administration window. Select the Configure tab, then select the
Upload/Download tab. Enter the relevant information to upload the configuration file.
6. From the Switch Status section, click Disable.
7.
8. Click Apply.
9. When prompted, click Yes to restart the SAN I/O Module in Access Gateway mode.
Command Line Interface
Complete the following steps to enable Access Gateway mode using the CLI.
1. Log in using the default administrative account.
2. Enter the following command to disable Full Fabric Switch mode.
3. Enter the following command to save the current configuration on the SAN I/O Module.
4. Enter the following command to enable Access Gateway mode:
16
See the Web Tools Administrator's Guide for more information on using Web Tools.
Login: admin
Password: password
The selected SAN I/O Module appears in the Switch View.
The Switch Administration window opens.
From the Access Gateway Mode section, click Enable.
The current Web Tools session closes; relaunch Web Tools after the SAN I/O Module reboots.
Login: admin
Password: password
switchDisable
This command is optional and is only required if you are converting an existing SAN I/O Module
to Access Gateway mode.
configUpload Save
ag ––modeEnable
4424 Blade Server SAN I/O Module Hardware Reference Manual
53-0000571-01
Advertisement
Table of Contents
