Table of Contents
Advertisement
DOK-GEAR**-GTE********-PR06-EN-P
Rexroth GTE Planetary Gearboxes
2
Important Instructions on Use
2.1
Intended Use
2.1.1
General Information
Introduction
2.1.2
Areas of Use and Application
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Rexroth products are developed and manufactured according to the state of
the art. Before they are delivered, they are inspected to ensure that they operate
safely.
The products must only be used as intended. If they are inappropriate used,
situations may arise resulting in injuries to property and persons.
Rexroth, as the manufacturer, does not provide any warranty, as‐
sume any liability, or pay any damages for damage caused by
products not being used as intended. Any risks resulting from the
products not being used as intended are the sole responsibility of
the user.
Before using the Bosch Rexroth products, the following condition precedent
must be fulfilled so as to ensure that they are used as intended:
●
Everyone who in any way whatsoever handles one of our products must
read and understand the corresponding notes regarding safety and re‐
garding the intended use.
●
If the products are hardware, they must be kept in their original state, i.e.
no constructional modifications must be made. Software products must
not be decompiled; their source codes must not be modified.
●
Damaged or improperly working products must not be installed or put into
operation.
●
It must be ensured that the products are installed according to the regu‐
lations specified in the documentation.
Typical application ranges of the GTE planetary gearboxes are:
●
Handling and Mounting systems,
●
Packaging and Food-processing machines,
●
Printing and Paper-processing machines and
Controlling and monitoring of the motor/-gearbox combination may require con‐
nection of additional sensors and actuators.
The gearboxes may only be used with the accessories specified in
the documentation. Components that are not explicitly mentioned
must neither be attached nor connected. The same is true for cables
and lines.
The operation must only be carried out in the explicitly mentioned
configurations and combinations of the component and with the
software and firmware specified in the corresponding functional de‐
scription.
Any drive controller must be programmed before startup, in order to ensure that
the motor executes the functions specific to the particular application.
Bosch Rexroth AG
Important Instructions on Use
9/85
Advertisement
Table of Contents
