Uart Tx/Rx Test; Dio Input/Output Test - DAQ cPCI-FRM11 User Manual

Step 2 : Press the "Frame Read" button. Then data are displayed on editor box. Compare the
contents of the editor box with the data of the Image Frame Simulator. Comparison can be
performed using the "Save to" button. It saves the contents of the editor box to a file.

6.2 UART Tx/Rx Test

At the above connection stage, make the image frame simulator to send UART data periodically.
Step 1 : Press the "UART init" button to initialize the UART and then press the "Start Timer" to get
the UART data from the Image Frame Simulator. Then the gotten data are displayed on the
editor box below the button. Compare the contents of the editor box with the data of the
Image Frame Simulator.
Step 2 : Write the data to the editor box beside the "Send Serial Data" button and press the "Send
Serial Data" button to send it to the Image Frame Simulator via the UART. Compare the
data on the editor box with that of the Image Frame Simulator.

6.3 DIO Input/Output test

Continue the test from the previous stage.
Step 1 : After to make all the output port "1‟‟ using "DIO Write" function of the test program, check
the output state using the oscilloscope. To check photo-coupler output, you have to prepare
some external circuit.
Step 2 : Using "DIO read" function, read out each input state. To make some activation of the photo-
coupler input, you need to prepare some external circuit.
cPCI-FRM11 User's Manual (Rev 1.1)
25
- - http://www.daqsystem.com