DAQ cPCI-FRM11 User Manual page 23

(3) „Clear Serial Data' button
Press this button to clear the contents of the editor box.
(4) „Start Timer' button
Press this button to start the timer. The sample program will read the UART data periodically.
The reading interval is around 0.1s.
(5) „Stop Timer' button
Press this button to stop the timer.
(6) „UART Init' button
Press this button to initialize UART. It must be performed only once after power is applied to
the board.
(7) „UART Close' button
Press this button to finish usage of the board and terminate the program.
5.1.3 Functions related to DIO
(1) „DIO Read' button
Press this button to read the data on General Purpose I/O port. It will be written an editor box.
(2) „DIO Write' button
Press this button to write the data on General Purpose I/O port. You can directly write the data
in the editor box beside the button.
cPCI-FRM11 User's Manual (Rev 1.1)
23
- - http://www.daqsystem.com