D-Link DSL-G604T Quick Installation Manual page 13

Configuring the Router (continued)
Static IP Connections
Static IP is used to set the Static IP mode for the Router. Static IP is used whenever a
known static IP address is assigned. The accompanying information such as the Subnet
mask and the gateway should also be specified in order to be able to connect. These are the
servers would enable you to have access to other web servers. Information entered here
must come from your ISP. You may change the PVC (Permanent Virtual Channel) settings
and the Encapsulation.
If you have
been told by
your ISP to
change the
VPI or VCI
number,
Type the
new values.
Select the Co nnection Type
Bridged IP LLC,
VC-Mux, 1483 Routed IP LLC, 1483
Routed IP VC-Mux
instructed by your ISP.
as 1483
1483 Bridged IP
or IPoA, as
Click the Next
Setup Completed menu below.
13
Type the IP addresses
for the WAN IP
Address, Subnet
Mask, ISP Gateway
Address, Primary DNS
Address and/or
Secondary DNS
Address, as instructed
by your ISP.
button. Skip ahead to the