Advertisement
Available languages
Available languages
BURST
CNTL SIGNAL
DELAY CNT
DAY NIGHT
NIGHT DAY
Option
BURST
CNTL SIGNAL
DELAY CNT
DAY NIGHT
NIGHT DAY
IR OPTIMIZATION SUBMENU
Option
MODE
IR AREA
LEVEL
COLOR NIGHT
IR SHADE COMP
DS 1092-171
D/N AUTO SETUP
ON
INT
■█■■■■■■■ 001
■■■█■■■■■ 060
■■■■█■■■■ 084
Value
ON ÷ OFF
INT ÷ EXT1 ÷
EXT2
0 ÷ 255
0 ÷ 255
0 ÷ 255
Value
AUTO ÷ CENTER
Top ÷ Bottom ÷
Left ÷ Right ÷
Weight
00 ÷ 12
ON ÷ OFF
ONO ÷ OFF
When active, colour burst is applied also with the camera
in black and white mode.
The control type used to select Day/Night mode.
EXT controls light sensors (CDS) in the camera to operate
the Day/Night mode selection.
In INT mode the switch is determined according to the
light on the sensor and the set parameters (see below)
instead of the CDS signal.
RECOMMENDED SETTING: Ext1
DO NOT USE Ext2 for this model.
This establishes the interval of time for the Day to Night
and from the Night to Day switch.
This defines the Day to Night switching level.
This defines the Night to Day switching level.
This configures the IR optimisation area.
Select CENTER in the MODE option to define an area.
IR optimisation intensity level.
This mode is used to take colour pictures in poor lighting
conditions also with infrared lighting. This camera can
reproduce colours when infrared lighting is activate by
managing the signal so as to separate the infrared
components of the image and extract the original colours
of the subject.
It is important to note that natural colours will not always
be reproduced in this mode.
Colour gain settings are: low, medium, high.
This is used to compensate a brightness difference in the
corners of the picture caused by IR light shadows. Do not
change the set parameters
Explanation
Explanation
31
Advertisement
