Getting Started; First Login - Emerson RXi2–BP Quick Start Manual

Getting Started

1. Connect the Ethernet cable to Ethernet port labeled ETH0 next to the 24 V power connector on the RXi2-BP.
2. Connect the 24 V +/-25% power plug.
3. Setup the User PC Ethernet port IP address to be statically assigned as follows:
a. Pv4 Static IP: 192.168.3.10 (or similar in the same subnet)
b. Netmask: 255.255.255.0
4. Power up the PACEdge unit and wait until it boots.
5. Open the browser of your choice and type in 192.168.3.100.
6. Note: all Ethernet ports are also configured to get IP addresses assigned by the DHCP server. This dynamically
assigned IP address can also be used to access PACEdge.

First Login

The first time you connect a warning message stating that the identity of the device could not be confirmed will be shown.
Please click on Advanced and Accept to proceed (this is due to self-signed certificate on the unit)
Please read and accept the Emerson End User License Agreement.
Shortcuts to Cockpit, Node-RED, Grafana, Portainer, and Chronograf will be shown on the PACEdge Landing Page (
Figure 4: PACEdge Landing Page
To explore PACEdge, click on Node-RED and log-in with:
•
user: admin
•
password: edgestack
Start exploring example flows or create your own flows. Consult the PACEdge User Manual (GFK-3178) for example details.
Important: Please consult the PACEdge Secure Deployment Guide (GFK-3197) for recommended password changes
and other Cyber Security relevant settings.
3 GFK-3196 - RXi2 - BP Industrial PC Quick Start Guide GFK-3196B