Table of Contents
Advertisement
4.1 Making a pressed connection
1. Cutting the pipe
Cut the pipe using a tool intended for cutting
thin-walled pipes.
2. Removing burrs
Remove all burrs from the cut pipe using a tool
intended for the purpose.
3. Cleaning
Clean any loose debris from the coupling head
and check that there are no sharp burrs on it.
8
4. Check the coupling heads
Check the coupling head of the pipe: it must be
circular and undamaged.
5. Marking the installation depth
Mark the correct installation depth on the pipe
using the Vexve installation depth gauge.
6. Checking the coupling heads of the valve
Visually inspect the valve's coupling head for any
damage and ensure that the O-ring is in place in
its groove.
www.vexve.com
Advertisement
Table of Contents
