Electrical Connection; Starting The Machine For The First Time - CPI STEMSHINE Operating Instructions Manual

To verify correct placement of the brushes, try to rotate them clockwise and then pull lightly
upwards: if the brush does not come off the support, placement is correct.

ELECTRICAL CONNECTION

First, verify that the power supplied corresponds to the machine's requirement by checking the
data on the label attached on the right hand side. Check that the electric plant and the socket
are suitable to supply a domestic appliance with a power of 1.8 Kw. If the socket does not
correspond to the plug, ask an electrician to change it. Do not employ an
adaptor as this may cause overheating and burning.
Never use an extension cord to reach the electric cable to the outlet. If the cable is not long
enough, reposition the glass polisher nearer to the outlet or have an electrician change out the
cable for a longer cable.
Ensure the cable does not rest on sharp edges and is not compressed or bent by other
objects.

STARTING THE MACHINE FOR THE FIRST TIME

This is the same procedure that you would engage for all subsequent start ups of the machine.
 Ensure the glass drier is placed in a location where the operator will find it comfortable
to operate.
 Ensure nothing is placed under the glass polisher that could obstruct air flow – i.e.
cloths
 Insert the plug into the nearest socket.
 Press the "Power" button located on t he front of the dryer to start up
the machine.
a. The button will illuminate indicating there is power to the unit.
b. The brushes will begin to rotate
c. The calrod element heats up
d. The fan will begin to circulate increasingly warm air around
the brushes.
WARNING: Ensure that no objects get caught in the rotation of the brushes.
Allow the brushes to heat up for approximately 10 – 15 minutes before
using the GP8 to dry glasses.
CPIGP8AOPINST
Page - 9 SALES + SERVICE
(866) 912-3469
WWW.CPISHINE.COM